The glaze mixing table integrates storage for raw materials and down draft extraction through a perforated work surface. Air is pulled down by a 1200 CFM inline fan through a pre and HEPA filter. The flexible outlet duct is positioned on the lower shelf which can be connected to a workshop extraction system or left to exhaust to the exterior air. The table can be configured with above table shelves and the steel frame powdered coated in your choice of tint. Shelves are finished in black formply for durability and easy cleaning. The unit is supplied on castors to allow portability around the studio.

Studio Neo x Loop Cycles

Made to order 6-8 weeks

$6,750.00 inc gst

The spray booth captures over sprayed material across four water surfaces dramatically reducing the exposure to silicate and oxide dust. The plumbing hardware, frame and wet surfaces are fabricated in stainless steel. A 150L tank houses the pump and a float valve inlet for easy filling. Water circulates up to the jet arms which sprays water down the three internal walls. As glaze material settles the clear water can be discharged from the system and the waste glaze collected. The booth is supplied on castors to allow for portability and easy cleaning. The unit including the pump, light and compressor.

Studio Neo x Fusionworks

Made to order 6-8 weeks.

$10,750.00 inc gst

The slip casting table comprises an aluminum top surface with slotted grill and powder coated steel frame on castors. A formply under shelf supports the weight of slip buckets and moulds for storage. The slip chute reduces down below the table level to accept a sieve and a 20L bucket. This design was considered around small to medium production volumes where changes to the type of slips happen regularly, limiting the surface area for cleaning. The aluminum grill has been sized so the table can also be used as a general worksurface in the studio.

Studio Neo x Loop Cycles

Made to order 6-8 weeks.

$6,450.00 inc gst